(no subject)

Pessoall,

Tenho um servidor fazendo as funções de roteador e DHCP ( 192.168.20.252 e 192.168.200.1).  Gostaria que somente a rede 192.168.200.0 fosse atendida pelo DHCP.
Já coloquei a opção INTERFACES="eth1" no arquivo /etc/sysconfig/dhcp e nãso funcionou.
Sempre que tento startar recebo a mensagem abaixo:

Iniciando dhcpd: Internet Software Consortium DHCP Server V3.0pl1
Copyright 1995-2001 Internet Software Consortium.
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP
Wrote 0 deleted host decls to leases file.
Wrote 0 new dynamic host decls to leases file.
Wrote 0 leases to leases file.
Listening on LPF/eth1/aa:aa:aa:11:11:98/192.168.200.0/24
Sending on   LPF/eth1/aa:aa:aa:11:11:98/192.168.200.0/24

No subnet declaration for eth0 (192.168.20.252).
** Ignoring requests on eth0.  If this is not what
   you want, please write a subnet declaration
   in your dhcpd.conf file for the network segment
   to which interface eth0 is attached. **

Can't bind to dhcp address: Address already in use
Please make sure there is no other dhcp server
running and that there's no entry for dhcp or
bootp in /etc/inetd.conf.   Also make sure you
are not running HP JetAdmin software, which
includes a bootp server.

If you did not get this software from ftp.isc.org, please
get the latest from ftp.isc.org and install that before
requesting help.

If you did get this software from ftp.isc.org and have not
yet read the README, please read it before requesting help.
If you intend to request help from the dhcp-server@xxxxxxx
mailing list, please read the section on the README about
submitting bug reports and requests for help.

Please do not under any circumstances send requests for
help directly to the authors of this software - please
send them to the appropriate mailing list as described in
the README file.

exiting.



Alguém tem alguma idéia?

Grato

Sérgio Adão