Hi,
I started having a problem this morning after I added an extra drive
to my ide1 channel as a slave.
After only 60 seconds the following messages started to appear on my
tty1 screen.
I immediatly removed the new disk and tried again with the same messages.
Next thing was removing and changeing the ide cable again this did not work.
I have read the following from another post but am unsure if this
would work also the file hardware does not exist on my FC5.
I would like to add the board was running windozes a few years back
and it started having disk problems. I then shelved it for 6 months
but Fedora seemed ok for the last year on it untill now.
Does anyone have any suggestions.
Nov 20 10:12:09 myth kernel: hda: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Nov 20 10:12:09 myth kernel: hda: dma_intr: error=0x10 {
SectorIdNotFound }, LBAsect=110169966, high=6, low=9506670,
sector=110169951
Nov 20 10:12:09 myth kernel: ide: failed opcode was: unknown
Nov 20 10:12:16 myth kernel: hda: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Nov 20 10:12:16 myth kernel: hda: dma_intr: error=0x10 {
SectorIdNotFound }, LBAsect=110169966, high=6, low=9506670,
sector=110169951
Nov 20 10:12:16 myth kernel: ide: failed opcode was: unknown
Nov 20 10:12:24 myth kernel: hda: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Nov 20 10:12:24 myth kernel: hda: dma_intr: error=0x10 {
SectorIdNotFound }, LBAsect=110169966, high=6, low=9506670,
sector=110169951
Nov 20 10:12:24 myth kernel: ide: failed opcode was: unknown
Nov 20 10:12:31 myth kernel: hda: dma_intr: status=0x51 { DriveReady
SeekComplete Error }
Nov 20 10:12:31 myth kernel: hda: dma_intr: error=0x10 {
SectorIdNotFound }, LBAsect=110169966, high=6, low=9506670,
sector=110169951
Nov 20 10:12:31 myth kernel: ide: failed opcode was: unknown
Nov 20 10:12:31 myth kernel: hda: DMA disabled
Nov 20 10:15:18 myth kernel: hdb: DMA disabled
Nov 20 10:16:29 myth kernel: ide0: reset: success
