I thought I knew how to do this. Thought I was prepared.
My FC6 has a simple RAID1 setup with two ATA HDD. Three paritions on
each drive (/boot, /, swap). Three RAID devices defined (i.e. hda1 &
hdc1 for md0, hda2& hdc2 for md1, hda3 & hdc3 for md2). works great,
can boot off either drive with the other powered down.
A week ago hda began to show disk read failures that seemed to increase
by the day (smartd). Checked hda with smartctl & hdd vendor test
software & sure enough drive was failing.
I removed hda from arrays (marked as failed then removed with mdadm).
Shutdown & replaced with new identical drive. Plan was to boot then use:
sfdisk -d /dev/hdc | sfdisk /dev/hda
to copy partition table from remaining good drive to newly installed
drive. Then add new drive back into arrays.
Surprise! boot hangs, cant find partitions on hda (of course not).
drops me to simple shell.
I do not understand why I was not able to boot using the remaining good
drive (hdc). I had done so prior during raid testing. machine acts
like doesnt see hdc.
What steps am I missing here. What should I have done ("best practice")?
Thanks in advance for any advice.
