ronald warsow wrote:
redhatdude@xxxxxxxxxxxxx wrote:
...
After following your instructions step by step, the configuration
script finally runs. What doesn't run is VMWare, if I try to launch it
from the terminal, it says that it was not configured correctly and
that I should run the configuration script once again.
EJ
but the error message related config.h is gone ???
that was where i was replying to !
(english ????!)
i suggest that vmware-config.pl has to run *with different/new network
options* - i tried it just right now -
i currently run vmware on:
...2.6.18-1.2798.fc6 #1 SMP ... x86_64 x86_64 x86_64
^^^^^^
without problems (except that smac warning) !
maybe you got some more trouble with vmware...
appendix:
did you install xinetd ????
--
ronald
