I have a PowerEdge 1600SC that has a RAID card and two 32 Gig drives that are mirrored. I picked up a Seagate 750GB hard drive and have it installed and hooked up using the 80 ribbon cable. I can go through the FC5 install and setup both drives. I'm not using LVM and set up /, /boot, and swap on the scsi drives and a separate ext3 partition on the 750GB drive. Install goes fine, but it will not boot up. I've tried putting grub on both the MBR and the first sector. The boot order matches what is in the BIOS. Any suggestions? Thanks, James
