On Wed, Sep 13, 2006 at 01:59:36PM +0000, Jim Douglas wrote: > I have an FC4 install on an old hard drive that has all my config setting > on it, > > My new FC5 install on a new hard drive complete. > > How can I mount the old hard drive so I can copy the settings and > eventually use it for backups? > This is where Fedora's policy on labeling partitions come in for criticism. Fedora labels a partition according to where it will be mounted. So your home partition (/home) is always labeled "/home". If you have the same partitioning scheme on two hard drives, installing them on the same machine would be a disaster. You MUST change the labels on one or the other. So the first step is to get yourself a live CD linux. I use finnix for this sort of thing. Then shut down, unplug the new hard drive, and plug the old one, leaving it temporarily set up as a single drive. Boot to the live CD and change the labels. "[man|info] tune2fs" and search on "label" for details. That done, re-rig the old hard drive as appropriate. * If you don't have an IDE CD-ROM drive as master on the secondary IDE controller, leave the old hard drive as a single drive and plug it into the secondary controller. It will show up as /dev/hdc. That's what I do on my desktop, which has a SCSI CD-ROM drive. * If you do have an IDE CD-ROM drive, chances are it is the secondary master. In that case, re-rig the old drive as a slave and plug it into the primary IDE controller cable, along with the new drive. It will show up as /dev/hdb. Also check the jumpers on the new drive. It is probably rigged as a single drive. This is usually (but not always) the same as the jumpering for a master. If necessary, change it to be a master. Boot. You should come up to the new drive. Edit /etc/fstab as appropriate. Be sure to make the mounts ro until you are done pulling what you want off of it. From my fstab: # old system.. /dev/hdc3 /mnt/oldsys ext3 owner,ro 1 2 /dev/hdc7 /mnt/oldsys/home ext3 owner,ro 1 2 /dev/hdc8 /mnt/oldsys/crcmisc ext3 owner,ro 1 2 Then create the old root partition's mount point: mkdir -p /mnt/oldsys You should then be able to mount, starting with the old root partition. Once you are sure everything is working, shut down and install the hard drives back into the case and close it up. -- Charles Curley /"\ ASCII Ribbon Campaign Looking for fine software \ / Respect for open standards and/or writing? X No HTML/RTF in email http://www.charlescurley.com / \ No M$ Word docs in email Key fingerprint = CE5C 6645 A45A 64E4 94C0 809C FFF6 4C48 4ECD DFDB
Attachment:
pgpMsVhENgLY8.pgp
Description: PGP signature
