Ed Greshko wrote:
Matt Singerman wrote:
The gateway will be replacing an existing one which is beginning to show
its age. It has static IP addresses for both the LAN and WAN, and the
machines behind it (servers) have publically-addressable static IP
addresses (not 10.x.x.x, 192.168.x.x, etc.). This is important, obviously.
I have found numerous guides online for setting up a gateway and
firewall using DHCP and NAT to use private IP ranges for machines on the
LAN, but this is obviously not what I want to do. I cannot find any
information about setting it up using all static IP addresses. I would
assume that this would be if anything simpler to configure, but I am
havind a devil of a time.
Our local subnet is the entire 141.161.111.0/24 block
(141.161.111.0-141.161.111.255). I have a working router on
141.161.111.241, and the subnet mask being used by all machines here is
255.255.255.0
Basically, I have eth0 configured to be the WAN connection, and it is
working fine. I can ping machines off the network, and machines can
ping it. Where I am running into problems is with IP forwarding
actually allowing connections through.
Here is eth0's config file:
DEVICE=eth0
ONBOOT=yes
BOOTPROTO=static
IPADDR=141.161.111.243
GATEWAY=141.161.111.241
NETMASK=255.255.255.0
NETWORK=141.161.111.0
eth1 is configured to be the LAN interface. It has the following settings:
DEVICE=eth1
BOOTPROTO=static
BROADCAST=141.161.111.255
HWADDR=00:0E:2E:79:F6:17
IPADDR=141.161.111.242
GATEWAY=141.161.111.242
NETMASK=255.255.255.0
NETWORK=141.161.111.0
ONBOOT=yes
I have modified /etc/sysctl.conf so that net.ipv4.ip_forward is set to 1.
Other than that... I am at a loss as to what to do. Can anyone point
me in the direction as to what my next step should be?
The IP address of ethO is 141.161.111.243 and the IP address of eth1 is
141.161.111.242. They are both on the same subnet. So, what are you
trying to do?
Hi Ed,
They are, yes - this should be possible, right? I am trying to firewall
off part of our network from the rest of the network and the outside
world. We have several servers with public IP addresses that are static
(they are servers). I would like for this Linux server to sit between
their outside connection to the world and the switch that all the
servers are plugged into, and act as a gateway and a firewall.
