I have had problems with this on FC3. I was never able to get it working under FC3.
I performed the test by using cp. (cp -a /backup/temp.tgz smbclient D:\winxp box:)
Linux: hda = PATA 100 80GB (IBM)
Linux: hdb = PATA 133 160GB (SEAGATE)
WinXP: C: = PATA 100 160GB (WD)
WinXP: D: = SATA 150 200GB (MAXTOR)
The only other protocol to try would be FTP or SFTP. I will try this also.
[root]# ethtool eth0
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Current message level: 0x00000037 (55)
Link detected: yes
[root]#
[root]# ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:15:F2:CD:9F:AA
inet addr:192.168.*.* Bcast:192.168.*.* Mask:255.255.255.0
inet6 addr: fe80::215:f2ff:fecd:9faa/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:9269058 errors:0 dropped:0 overruns:0 frame:0
TX packets:11317916 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4000895702 (3.7 GiB) TX bytes:3254841363 (3.0 GiB)
Interrupt:177
[root]#
[root]# ethtool -i eth0
driver: skge
version: 1.5
firmware-version: N/A
bus-info: 0000:00:0a.0
[root]#
TIA
Matt
