Jay Cliburn wrote:
On Thu, Jul 20, 2006 at 02:38:01PM +0100, Chris Jones wrote:
Justin Willmert wrote:
Chris Jones wrote:
Nicolas Mailhot wrote:
Le mercredi 19 juillet 2006 à 21:08 +0100, Chris Jones a écrit :
I have chosen to install amavis-new with my FC5 installation. This
also loads clamav. However, when I look at the amavis service, I
get the response "amavisd dead but subsys locked". I have checked
everything I can think of, but cannot get amavisd to start. Does
anyone here have any suggestions?
1. remove the dangling lock
2. start amavis
3. take a peek in /var/log/maillog
I looked for the dangling lock. However, I can find nothing. I would
expect to find it (with amavisd running) at /var/run/amavisd/ along
with the pid file, but there is nothing. Where else should I look?
Try looking in /var/lock/subsys.
I have tried that. I removed the hanging lock, which when checked,
stopped amavisd. However, on starting amavisd, apparently successfully,
after checking the status, amavisd was again dead but subsys locked.
I seem to be going around in circles. HOW do I correct this???
Perhaps you're being hit by these seemingly related bugs.
https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=199014
https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=199044
I do not think that either of these directly relate to me. I am running
2.6.16-1.2122_FC5 x86_64, so 199014 does not apply as that is FC6.
199044 seems to only relate to cpuspeed, whereas I am unable to run
amavisd and sometimes clamd.amavisd.
--
Chris Jones
