Re: FC-5 post-install networking troubleshooting help

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, 2006-06-21 at 07:44 -0500, Peter Horst wrote:
> I'm trying to get a new install of fc-5 onto a (working) DHCP network.  
> During install I checked the appropriate "use dhcp" boxes.  Now when I'm 
> booting I get:
> 
> Bringing up interface eth0:
> Determining IP information for eth0... failed.
> 
> So no network.  Where do I start looking? Thanks for any pointers.
> 
> BTW, X-windows is not installed.

Check that you have a good link light on the NIC and the switch port.
Verify that the cable is good.  

Describe your setup, what is providing DHCP?  What kind of switches and
NIC are you using?  Is the switch port set to auto-negotiate or is it
locked down to full duplex/100Mb or half duplex/10Mb?

Output from the following commands would help:

/sbin/ifconfig -a

cat /etc/resolv.conf

/bin/netstat -rn

cat /etc/hosts

/sbin/ethtool eth0       (note: you will need to be root for this one,
use the interface for your network connection if it is not eth0)




[Index of Archives]     [Current Fedora Users]     [Fedora Desktop]     [Fedora SELinux]     [Yosemite News]     [Yosemite Photos]     [KDE Users]     [Fedora Tools]     [Fedora Docs]

  Powered by Linux