Dario Lesca wrote: > Hi, I must configure a External USB Ethernet adapters D-Link DUB-E100, > this is the my /proc/bus/usb/drivers info: > > T: Bus=01 Lev=01 Prnt=01 Port=01 Cnt=01 Dev#= 4 Spd=480 MxCh= 0 > D: Ver= 2.00 Cls=ff(vend.) Sub=ff Prot=00 MxPS=64 #Cfgs= 1 > P: Vendor=07d1 ProdID=3c05 Rev= 0.01 > S: Manufacturer=D-Link Corporation > S: Product=DUB-E100 > S: SerialNumber=000001 > C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=250mA > I: If#= 0 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=ff Prot=00 Driver=(none) > E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=128ms > E: Ad=82(I) Atr=02(Bulk) MxPS= 512 Ivl=0ms > E: Ad=03(O) Atr=02(Bulk) MxPS= 512 Ivl=0ms > > when I plug the adapters into USB port I get this dmesg info: > > usb 1-2: new high speed USB device using ehci_hcd and address 5 > usb 1-2: configuration #1 chosen from 1 choice > > ... but none happening. > > I have found this web page > http://www.linux-usb.org/usbnet/ > which say then this device is support from asix driver (and usbnet). > > But if I modprobe this drivers none happening ... > the "ip addr" command not show a new net network device. > > It is possible to use this device? > How I can configure this device? > > Many thanks to all! > What does "ifconfig -a" show? Mikkel -- Do not meddle in the affairs of dragons, for thou art crunchy and taste good with Ketchup!
