Paul Howarth wrote:
On Sun, 2006-06-04 at 08:05 +0200, A.J. Bonnema wrote:
Hi all,
I draw my configuration of ethernetcards:
PC (eth0 10.0.0.1)-->3com switch-->speedtouch(10.0.0.138)-->theNet
PC (eth1 192.168.1.10)-->FSG (192.168.1.1)-->speedtouch(10.0.0.138)
I apologize, there is one small inacuracy in the second line. It should
read:
PC (eth1 192.168.1.10)-->FSG (192.168.1.1)-->3com
switch-->speedtouch(10.0.0.138)
The WAN port of the FSG is unused. It is connected to the 10.0.0-network
through the 3com switch.
Remove any GATEWAY settings in /etc/sysconfig/network-scripts/ifcfg-*
and add to /etc/sysconfug/network:
GATEWAY=10.0.0.138
Paul.
Hi Paul and Craig (who gave the same advice),
I did what you said and nothing changed. The resulting route was:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth1
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth1
The contents of /etc/sysconfig/network is:
NETWORKING=yes
HOSTNAME=athene
GATEWAY=10.0.0.138
The contents of /etc/sysconfig/networking/devices/ifcfg-eth0 is:
DEVICE=eth0
ONBOOT=yes
IPADDR=10.0.0.1
NETMASK=255.255.255.0
METRIC=1
TYPE=Ethernet
USERCTL=no
IPV6INIT=no
PEERDNS=yes
BOOTPROTO=none
The contents of /etc/sysconfig/networking/devices/ifcfg-eth1 is:
DEVICE=eth1
ONBOOT=yes
IPADDR=192.168.1.10
NETMASK=255.255.255.0
METRIC=10
TYPE=Ethernet
USERCTL=no
IPV6INIT=no
PEERDNS=yes
BOOTPROTO=none
The route I need to end up with is:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
10.0.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1
169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth1
0.0.0.0 10.0.0.138 0.0.0.0 UG 0 0 0 eth0
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth1
where the last line is probably unnecessary.
--
A.J. Bonnema, Leiden The Netherlands,
user #328198 (Linux Counter http://counter.li.org)
