LC wrote:
Hi,
I am trying to make a router using a FC4. I have 2 NICs in the machine.
Install FC4 using minimium. Eth0 is set to DHCP, connected to an
ethernet modem and ETH1 has IP 192.168.1.1, netmask 255.255.255.0
connected to a switch. Installation was a success and rebooted the box.
Clients machines are unable to ping 192.168.1.1. But when i unplug the
modem and reboot, clients are ablt to ping 192.168.1.1. I realised if
the box booted up both ETH0 and ETH1, clients are able to ping
192.168.1.1. But if i ifdown ETH0 and ifup ETH0, clients are able to get
reply from 192.168.1.1.
Can someone tell me what should I do?
Best regards
/etc/sysctl.conf:
# Controls IP packet forwarding
net.ipv4.ip_forward = 0
^
--
Bob Marcan, Consultant mailto:bob.marcan@xxxxxx
S&T Hermes Plus d.d. tel: +386 (1) 5895-300
Leskoskova cesta 6 fax: +386 (1) 5895-202
1000 Ljubljana, Slovenia url: http://www.snt.si
