Aaron Konstam wrote:
On Thu, 2006-04-20 at 15:21 -0400, Bob Goodwin wrote:
John Mason Jr wrote:
Bob Goodwin wrote:
Can anyone suggest a "wireless" router they have had success with?
I bought a Linksys WRT54g, gave up on it and returned it. The
installation software only works with Windows and our efforts at
installing it on a Mac were frustrating to say the least. Tech
support is through New Delhi, the people are fine but the language
problem is near impossible! That was replaced with a Belkin 54g
which at least came with usable installation software but the
quality is poor, I'm about to return the second one with an
intermittent power connector which has been causing maddening problems.
You should be able to enter all the setup info via web interface
Yes, if you can bring up the web interface, it doesn't always work.
My FC5 Linux system has a Linksys WET54G "wireless" bridge. I
discovered that when you get that configured wrong there is no way to
restore factory defaults except with a Windows computer and the
supplied installation software.
Linksys user manual shows a reset button, but this may be different
than your model/version number
The instructions tell you to press reset and/or pull the power plug and
if that fails use the install software. I have never been able to
verify that the reset button does anything of value to me? I've pressed
it numerous times to no avail.
I think you have to od more than push it . You have to hold id for 10
seconds for the reset to be effected.
I once had to reset a Linksys router, and what I did was
hold the reset button for 30 seconds, then powered down
while holding the button, waited 10 to 30 seconds, then
powered up and waited 30 seconds, then released. The reset
button was held continuously during this period.
Mike
--
p="p=%c%s%c;main(){printf(p,34,p,34);}";main(){printf(p,34,p,34);}
This message made from 100% recycled bits.
You have found the bank of Larn.
I can explain it for you, but I can't understand it for you.
I speak only for myself, and I am unanimous in that!
