Ivan Evstegneev wrote:
1) Locating the SWAT File:
rpm -ql samba-swat
In addition to the commands you already used, this will tell you
everything associated with swat.
******* here some little "spike" appeared, in my case I can only view
the man pages for "strings" command but when I tried to run it, I got "command not found".
and 'cause of it I followed the next instruction:
Oddly, the man page for "strings" is a part of the "man-pages" rpm,
rather than the binutils (I think) that contains "strings".
******* but for the /usr/share/samba/swat I got nothing. But when I changed a path to "/usr/share/swat"
it described me all those files listed above. So now you see that the only difference between how-to's paths and mine
is that I have swat supported files in "/usr/share/swat" folder and not in "/usr/share/samba/swat"...
Actually I created "samba" folder and copied there swat files... but as you can observe it got no effect.
You didn't need to do that, and should remove the files that you copied.
4) Enabling SWAT for Use.
***** So I found my "xinetd.conf" and added the following lines as they
asked me:
The samba-swat rpm contains an xinetd file, which should be
/etc/xinetd.d/swat. You can enable swat with "chkconfig swat on".
Remove the lines that you added to xinetd.conf, as they may conflict
with the file contained in the samba-swat package.
******* Then I opened my firefox and wrote this command:
"http://localhost:901/"; but it didn't work...
It will after you remove the section you added, and use "chkconfig" to
enable swat. :)
