Can someone point me to a procedure for setting up a "wireless" adapter
card?
I have ndiswrapper and the Windows driver that came on a CD with the
Linksys [wmp54g] PCI card.
ndiswrapper -l
Installed drivers:
rt2500 driver installed, hardware present
I did modprobe ndiswrapper.
And iwconfig reports:
lo no wireless extensions.
eth0 no wireless extensions.
sit0 no wireless extensions.
wlan0 IEEE 802.11g ESSID:off/any
Mode:Auto Frequency:2.412 GHz Access Point: Not-Associated
Bit Rate:54 Mb/s Tx-Power:20 dBm Sensitivity=-109 dBm
RTS thr:2347 B Fragment thr:2346 B
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ppp0 no wireless extensions.
This is as far as I got, don't know what to do next. I'd like to see
some indication that it sees the router which is presently on an XP box
about six feet away.
Bob Goodwin
