ADSL has Ethernet port and a USB port.
(when I did FC5 setup, It was switched off)
eht0 could be configured later on and is working fine.
But unable to config the eth1 (usbnet) port.
USB CDC Ethernet Driver is selected ( as in FC4)
all settings are same as FC4 but not working.
# lsusb
Bus 004 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 003 Device 002: ID 2001:5b00 D-Link Corp. [hex]
Bus 005 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
# usbview gives full details of the device (I mean it is present and correct),
can someone tell - how to invoke/start this device for FC5
MTIA
--
Anil Kumar Shrama
