latest kernel 2.6.16-1.2080_FC5 x86_64 starts with udev OK then brings up message about unable to open/read? /lib/modules/2.6.16-1.2080_FC5/modules.dep. It then boots through without loading any drivers to firstboot screen, of course without keyboard or mouse loaded so I can't get to vt1. booting into runlevel 1 leaves me without keyboard. I suspect it is not mounting the (shuttle SN25P SATA nforce4) / partition but without any error logging cos there is nothing in messages... how can I track the problem? BTW kernel 2069 from testing that I tried yesterday has same fault. fstab is bog standard... LABEL=/ / ext3 defaults 1 1 LABEL=/boot /boot ext3 defaults 1 2 devpts /dev/pts devpts gid=5,mode=620 0 0 tmpfs /dev/shm tmpfs defaults 0 0 proc /proc proc defaults 0 0 sysfs /sys sysfs defaults 0 0 disk partition (from FC4 dual boot cos I'm not mad ;)... Disk /dev/sda: 160.0 GB, 160041885696 bytes 255 heads, 63 sectors/track, 19457 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sda1 * 1 26 208813+ 83 Linux /dev/sda2 27 7674 61432560 83 Linux /dev/sda3 7675 7801 1020127+ 82 Linux swap / Solaris /dev/sda4 7802 19457 93626820 5 Extended /dev/sda5 7802 19457 93626788+ fd Linux raid autodetect
