Marcel Janssen wrote: > Hi, > > I've added a second sata drive to my system and I see from dmesg that it is > being added : > nv_sata: Secondary device added Not a lot of messages here to tell by. I only have 1 SATA disk installed on my system, but I see: > libata version 1.20 loaded. > sata_nv 0000:00:0b.0: version 0.8 > PCI: Setting latency timer of device 0000:00:0b.0 to 64 > ata1: SATA max UDMA/133 cmd 0x9F0 ctl 0xBF2 bmdma 0xCC00 irq 10 > ata2: SATA max UDMA/133 cmd 0x970 ctl 0xB72 bmdma 0xCC08 irq 10 > ata1: dev 0 cfg 49:2f00 82:346b 83:5b01 84:4003 85:3469 86:1801 87:4003 88:203f > ata1: dev 0 ATA-6, max UDMA/100, 78125000 sectors: LBA > nv_sata: Primary device added > nv_sata: Primary device removed > nv_sata: Secondary device removed > ata1: dev 0 configured for UDMA/100 > scsi1 : sata_nv > ata2: no device found (phy stat 00000000) > scsi2 : sata_nv > Vendor: ATA Model: WDC WD400BD-75JM Rev: 05.0 > Type: Direct-Access ANSI SCSI revision: 05 > SCSI device sdb: 78125000 512-byte hdwr sectors (40000 MB) > SCSI device sdb: drive cache: write back > SCSI device sdb: 78125000 512-byte hdwr sectors (40000 MB) > SCSI device sdb: drive cache: write back > sdb: sdb1 sdb2 > sd 1:0:0:0: Attached scsi disk sdb (yes, I have a small real SCSI drive on my system, so my SATA drive is sdb.) > But, where can I find it ? You need to look further into your /var/log/dmesg file to find all of the messages associated with your drive. If you don't see it there, perhaps you have a cabling issue? > I check in /dev and expected something like /dev/sdb but it doesn't exist. Stuff in /dev is created either during boot, or by hotplug events. If the system doesn't see the drive, there won't be a device node for it in /dev . -- Kevin J. Cummings kjchome@xxxxxxx cummings@xxxxxxxxxxxxxxxxxx cummings@xxxxxxxxxxxxxxxxxxxxxxx Registered Linux User #1232 (http://counter.li.org) -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
