Bob Chiodini wrote:
On Thu, 2005-12-22 at 12:11 +0100, Eric Doutreleau wrote:
Tim wrote:
On Wed, 2005-12-21 at 16:11 +0100, Eric Doutreleau wrote:
i have a lab with fedora core 4 machine with a network card
01:08.0 Ethernet controller: Intel Corporation 82562EZ 10/100 Ethernet
Controller (rev 02)
and from time to time the network seems not working anymore.
after a few second the network goes up again.
The result is that i lose about 30% of packet.
when i boot windows on the same machine i have the same problem.
That does seem to suggest a hardware fault (a bad NIC, or the
combination of your motherboard and NIC). Can you try a different one?
well i made a mistake with my sentence
i have no problem under windows
and i have 12 same computer and all have the problems with FC4
nevertheless thanks for your answer
Eric,
What does ethtool eth0 tell you about the interface? Are you getting
any errors in /var/log/messages concerning eth0?
This sounds like an autonegotiation (duplex) problem.
Bob...
here is the result
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: g
Current message level: 0x00000007 (7)
Link detected: yes
the only thing i got from messages concerning eth0 is theses messages
Dec 22 12:17:04 b02-07 kernel: e100: eth0: e100_probe: addr 0xfc000000,
irq 11, MAC addr 00:0C:76:E5:E8:C8
Dec 22 12:17:08 b02-07 kernel: e100: eth0: e100_watchdog: link up,
100Mbps, full-duplex
Dec 22 12:17:15 b02-07 ntpd[2459]: Listening on interface eth0,
157.159.15.231#123
