-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 I've done the last three version of g4l (0.15, 0.16, and 0.17), and everything has gone fine. The last issue that I would like to resolve is to be able to use names instead of having to use IP addresses. I had added dhcpd support for getting the ip address of the system. The ping command and ncftp have no problem working with IP address, but not with names. The dhcpd sets up the resolv.conf with the nameserver, but no resolution. traceroute fails with a message about there not being the icmp protocol, but it works for ping. What I found so far mentioned the protocol and services files being needed. I added that, but it didn't change the results. I'm pretty sure it is something minor that I am missing, I don't see anything in the kernel config options, but I could be wrong. Perhaps someone has done something similar. G4L is a disk imaging system uses dd compression and ftp to make and restore images. I had almost 9000 downloads of the new version in November (iso and source). Any ideals would be appreciated. Thanks. +----------------------------------------------------------+ Michael D. Setzer II - Computer Science Instructor Guam Community College Computer Center mailto:mikes@xxxxxxxxxxxxxxxx mailto:msetzerii@xxxxxxxxx http://www.guam.net/home/mikes Guam - Where America's Day Begins +----------------------------------------------------------+ http://setiathome.berkeley.edu Number of Seti Units Returned: 18,823 Processing time: 32 years, 168 days, 23 hours, 32 minutes (Total Hours: 284,376) -----BEGIN PGP SIGNATURE----- Version: PGP 6.5.8 -- QDPGP 2.61c Comment: http://community.wow.net/grt/qdpgp.html iQA/AwUBQ59hUSzGQcr/2AKZEQJekACePuSm9wKwAsONeo26OdjTQcgD16YAn3fL VSXikMRl+rrqzuIiUnSL/Jxu =eeaU -----END PGP SIGNATURE-----
