I realize i'm not the sharpest knife in the drawer but I want to believe that I'm not as dumb as a sack of nickles. In the absence of substance, allow me to cut right to the jargon Installed FC4 with Kernel 2.6.14.3. I have a Linksys WPC54Gv2 which works great with ndiswrapper. (Yay for > 4K Stacks) I want to use Kismet but it doesn't support ndiswrapper - great.' After searching high and low I ran across some [archive] forum (https://www.redhat.com/archives/fedora-list/2005-August/msg03945.html) where a gentleman was able to get his WPC54G WiFi card to work. #lspci 09:00.0 Network controller: Texas Instruments ACX 111 54Mbps Wireless Interface #lspci -n 09:00.0 Class 0280: 104c:9066 Attempting to follow his steps and the links provided, I did a little due diligence, and thought I found a potential solution but later got confused. I've been bouncing between the following four sites for guidance on getting my card to work: http://195.66.192.167/linux/acx_patches/acx_fw/acx111_xterasys_xn2522g/fw3/ http://www.houseofcraig.net/acx100_howto.php http://acx100.sourceforge.net/ http://lisas.de/~andi/acx100/ I read most of the documentation on the very last page mentioned above but stopped after getting down to the 'USAGE HINTS' area as I got a little confused when it came to the 'FIRMWARE INSTALLTION' section. Here I'll detail what I did, and hopefully someone can nudge me in the correct direction: copied my FwRad17.bin to firmware/ as TIACX111.BIN ran 'make inject KSRC=/path/to/kernel/src' which appeared to run ok ["Process successfully completed. Enjoy it!"] After that I could not figure out where to go. FYI the binary files that came with the drivers: Fw1130.bin FwRad16.bin FwRad17.bin radio16.bin radio17.bin I'm also concerned that I did not put the correct .bin files in the correct location(s[?]). I am no looking to be spoonfed - I would just like a little advice (maybe more documentation) and a thumbs up/thumbs down as to what I did and a nudge in the correct direction. Thanks. Julius
