ifcfg-eth0
::::::::::::::
DEVICE=eth0
BOOTPROTO=static
BROADCAST=10.1.4.30
HWADDR=01:10:26:19:12:B5
IPADDR=10.1.4.2
NETMASK=255.255.255.192
NETWORK=10.1.4.0
GATEWAY=10.1.4.35
> TYPE=Ethernet
ifcfg-eth0:0
::::::::::::::
DEVICE=eth0:0
IPADDR=10.1.4.1
On 12/1/05, jludwig <wralphie@xxxxxxxxxxx> wrote:
On Friday 02 December 2005 12:51 am, Jonathan Carpenter wrote:
> I have setup one server for multiple ips. But when I bring eth0 down and
> then back up I get and error of:
>
> SIOCADDRT network is unreachable
>
> I am not exactly sure why I am getting this message everything seems to
> work fine. I can access anything from this server and I can access this
> server from anywhere. I have noticed some collisions and transmit errors. I
> am not sure what would be causing this.
>
> ifconfig returns
> eth0 Link encap:Ethernet HWaddr 01:10:26:19:12:B5
> inet addr:10.1.4.2 Bcast:10.1.4.30 Mask:255.255.255.192
> inet6 addr: fe80::214:22ff:fe17:15a9/64 Scope:Link
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:248569 errors:0 dropped:0 overruns:0 frame:0
> TX packets:71281 errors:66 dropped:0 overruns:0 carrier:66
> collisions:180 txqueuelen:1000
> RX bytes:80778446 (77.0 MiB) TX bytes:14645178 (13.9 MiB)
> Base address:0xecc0 Memory:fe6e0000-fe700000
>
> eth0:0 Link encap:Ethernet HWaddr 01:10:26:19:12:B5
> inet addr:10.1.4.1 Bcast:10.1.4.30 Mask:255.255.255.192
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> Base address:0xecc0 Memory:fe6e0000-fe700000
>
> lo Link encap:Local Loopback
> inet addr: 127.0.0.1 Mask:255.0.0.0
> inet6 addr: ::1/128 Scope:Host
> UP LOOPBACK RUNNING MTU:16436 Metric:1
> RX packets:6762 errors:0 dropped:0 overruns:0 frame:0
> TX packets:6762 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:274642 (268.2 KiB) TX bytes:274642 (268.2 KiB)
>
> route -n shows
> Kernel IP routing table
> Destination Gateway Genmask Flags Metric Ref Use
> Iface
> 10.1.4.0 0.0.0.0 255.255.255.192 U 0 0 0 eth0
> 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0
> eth0 0.0.0.0 10.1.4.35 0.0.0.0 UG 0 0 0
> eth0
>
> Thanks,
> --
> Jonathan Carpenter
> Linux System Administrator
> Windows System Administrator
> <The Unix Geek>
I'll bet that you may have eth0:0 set up as the gateway. If that is the case
eth0 may not be able to see "the network".
(I have seen this type of weirdness before.)
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
--
Jonathan Carpenter
Linux System Administrator
Windows System Administrator
<The Unix Geek>
