On Thu, 2005-11-17 at 14:23 -0500, James Pifer wrote: > > Try one of these versions: > > > > iwconfig wlan0 mode ad-hoc essid <ESSID> key restricted <KEY-STRING> > > iwconfig wlan0 mode managed essid <ESSID> key restricted <KEY-STRING> > > > > My guess is that ad-hoc will work. Without the mode spec, sometimes > > iwconfig won't set the frequency or allow the essid. Weird, but true. > > You might also try removing the "restricted" keyword--your network may > > not be in that mode and using "restricted" limits you to truly > > restricted networks. > > > > And yes, I have it working on several WEP networks using D-Link access > > points and routers and using ASCII key strings. Note that they're > > ad-hoc networks, but it should work on managed as well. > > > > The networks are old D-Link DI-614+ routers with DI-900AP access points. > > ndiswrapper is managing a Broadcom wireless chip in my laptop and I use > > an iwconfig of: > > > > iwconfig wlan0 mode ad-hoc essid xxxxxx key s:blah-blah > > > > Works peachy! > > > > Rick, > > I tried Ad-hoc and indeed it does load, but now mine loads like its own > AP, not connecting to DLINK AP. It's sets itself up as its own cell: > > wlan0 IEEE 802.11g ESSID:"my-essid" Nickname:"me.mydomain.com" > Mode:Ad-Hoc Frequency:2.437 GHz Cell: D6:D5:6D:44:61:93 > Bit Rate=54 Mb/s Tx-Power:25 dBm > RTS thr=2347 B Fragment thr=2346 B > Encryption key:1234-1234-1234-1234-1234-1234-12 Security > mode:restricted > Power Management:off > Link Quality:100/100 Signal level:-57 dBm Noise level:-256 > dBm > Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 > Tx excessive retries:0 Invalid misc:0 Missed beacon:0 > > If I do an iwlist scan I see my DLINK AP as one cell and my laptop as > another cell. Then try "managed" instead of "ad-hoc" and see what happens. Remember, you have to set the ESSID to the same as your DLink stuff. > Also, in your example you said: > iwconfig wlan0 mode ad-hoc essid xxxxxx key s:blah-blah > > What is the "s:" after key, and you don't use the dashes in your key > correct? I use ASCII string WEP keys. The "s:" tells iwconfig that it's an ASCII string rather than a string that represents hex values, e.g. "abcdef" means three bytes of hex values, 0xab, 0xcd and 0xef "s:abcdef" means a six-byte ASCII string, "abcdef" ---------------------------------------------------------------------- - Rick Stevens, Senior Systems Engineer rstevens@xxxxxxxxxxxxxxx - - VitalStream, Inc. http://www.vitalstream.com - - - - When all else fails, try reading the instructions. - ----------------------------------------------------------------------
