> Okay, now I'm running a kernel with 16k stacks. I also loaded
> ndiswrapper 1.5.
>
> I can load everything like this:
>
> ndiswrapper -i /install/ndiswrapper/broadcom/bcmwl5.inf
> /sbin/modprobe ndiswrapper
> /sbin/iwconfig wlan0 mode Managed
> /sbin/iwconfig wlan0 key my_key_goes_here
> /sbin/iwconfig wlan0 essid my_ssid_goes_here
> /sbin/ifconfig wlan0 192.168.1.25 netmask 255.255.255.0 up
>
One more thing. If I run iwconfig after running the above commands I get
this:
wlan0 IEEE 802.11g ESSID:off/any
Mode:Managed Frequency:2.462 GHz Access Point:
00:00:00:00:00:00
Bit Rate:54 Mb/s Tx-Power:25 dBm
RTS thr:2347 B Fragment thr:2346 B
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
It doesn't show the ESSID, says Encryption is off, and Access Point
address of 00:00:00:00:00:00.
I assume these settings are part of my problem. Why didn't the settings
"take"? Anyone know what I am doing wrong?
Thanks,
James
