I'm using the Tyan K8WE board (which uses the same chipset as the K8SE) with an external PCI-X 29160 and it works just fine. However, with the older BIOS, using the default ISO kernel, FC3 (be that 32bit or 64bit) failed to detect and configure the Adaptec card. I'd try the following: A. Check Tyan's website for BIOS upgrade. B. Try booting with "noapic". C. Try both the 32bit and the 64bit versions. I found that the 64bit worked much better. D. Post your "/proc/interrupts" and "lspci -vv" here. Gilboa On Mon, 2005-10-17 at 18:37 +0200, Markus Fritz wrote: > Hallo, > > I have tried to install FC4 on a Tyan Thunder K8SE with onboard > Adaptec 7902 (Tyan TARO) and Adaptec 29320 but cannot access any disks. > There are no other cards in the system, Video is onboard ATI Rage XL. > > I have tried 'noacpi', doesn't help. > 'noprobe' with manually loading drivers. > > I have also tried Knoppix 2.6 and FC3, but same Problem. > FC3 core dumps when i tried to load the aic79xx driver, the aic7xxx > driver loads fine but no disks showing. > > Win2003 has been tested and is running fine, refering to out vendor .. > > Has anybody success in running this motherboard and one of these > SCSII-Controllers ? > > 'dmesg' shows some problems in IRQ-config, that i suspect is the > problem. Since the system has no floppy it is hard to provide a full > dmesg -- but i will try ... > > > Thanks, > > Markus > > -- > Dipl.-Ing. (FH) Markus Fritz > Just Innovative Software GmbH * Robert-Bosch-Str. 32 * 74081 Heilbronn >
