I fully apologize
The problem I got with the highest screen resolutions, disappears when
I startx as root.
The fact is, after installing the nVidia IA32 driver, I removed the
last DRI item in the xorg.conf, and I don't remember exactly what it is.
This is the last item in this file, after the Screen paragraph.
Afterwards, I removed the nVidia driver with the 'nvidia-installer
-uninstall' program.
May I be allowed, to ask for you to send to me, an example of this
last DRI item in xorg.conf ?
I recall this was for permissions purpose, but I don't remember
exactly the syntax.
Thank you very much.
Best regards.
Jean Francois Ortolo
--- Begin Message ---
Hi
I've got built an AMD64 2GHz, 1 giga-bytes DDR-RAM 400MHz, an ASUS
A8E-N motherboard, an ASUS GeForce 6200 graphic card, and a LG Flatron
L1730S monitor. All works fine, except that I cannot set the screen
resolution above 800x600 pixels.
Neither the graphic card nor the monitor were identified during the
install. The default driver vesa was used by the install process.
Whenever I try to change the screen resolution to 1024x768 in the
"server settings" menu -> "screen resolution" sub-menu from X as root,
the xorg.conf file is being changed accordingly by adding the proper
resolution before the previous one in the Modes lines near the Video
Card item, however this way, when I run startx, the X server runs, then
the virtual screen is much smaller than the entire screen, such that no
button is available on the horizontal menu bar, then I'm obliged to kill
the X server by hitting Ctrl-BackSpace keys.
Meanwhile, the Horizontal/Vertical refresh rates of the monitor have
been set up properly, according to a web site which gives its
characteristics. I'm pretty sure the characteristics are correct.
The reason why I get those characteristics from the web site, is I no
longer have the monitor manual, I don't remember where I left it :(
I've got this problem before installing the nVidia IA32 driver, and
after installing it also.
It seems this problem is not a driver problem, but might be a simple
configuration problem, but I don't know what to do for solving it.
I would be fully recognizing for any advice or suggestion, for I need
to have this resolution set up, and higher resolutions too.
Many thanks for your help.
Best regards.
Jean Francois Ortolo
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
--- End Message ---
