Where do I find the link status - 10mps, 100mps,
half-duplex, duplex, etc - for a 3Com ethernet adapter in fc4.
I have two adapters on this machine, eth1 is the 3Com. dmesg
shows:
.......................
8139too Fast Ethernet driver 0.9.27
eth0: RealTek RTL8139 at 0xfc00, 00:48:54:8b:ab:29, IRQ 11
eth0: Identified 8139 chip type 'RTL-8139B'
3c59x: Donald Becker and others.
www.scyld.com/network/vortex.html
0000:00:0f.0: 3Com PCI 3c595 Vortex 100baseTx at 0xff80.
Vers LK1.1.19
0000:00:0f.0: Overriding PCI latency timer (CFLT) setting of
64, new value is 248.
..............
eth0: link up, 10Mbps, half-duplex, lpa 0x0000
..................
eth1: no IPv6 routers present
eth0: no IPv6 routers present
......
ifconfig doesn't help.
???
sean
