For future reference ... It works now !!
http://195.66.192.167/linux/acx_patches/acx_fw/acx111_xterasys_xn2522g/fw3/
used the xterasys_xn2522g drivers,
76268 d5147672b1e00ba61d0eff24c064bfe9 Fw1130.bin_1.2.0.30
7208 ae57fc2f9fb79d421314c8ba95af0123 RADIO16.BIN
just copy Fw1130.bin to /usr/share/acx/TIACX111.BIN
and RADIO16.BIN to /usr/share/acx/RADIO16.BIN
#modprobe acx_pci
On Sun, 21 Aug 2005 00:31:25 +0300, Efthym <efthym@xxxxxxx> wrote:
Hi all,
I've been trying to setup up this card using the native linux driver with
no luck. I followed the directions at
http://www.houseofcraig.net/acx100_howto.php
since "lspci -n" says the chipset is 104c:9066. I downloaded
acx100-0.2.0pre8_plus_fixes_57.tar.gz and copied RADIO16.BIN from the
vendor cd to /usr/share/acx. The module compiled and loaded perfectly,
but
"iwlist wlan0 scan" does not return any results and DHCP does not receive
an IP. I'm not using WEP or any encryption.
Here are some outputs I get.
[root@purgatory WPC54Gv2_40826]# ifconfig wlan0
wlan0 Link encap:Ethernet HWaddr 00:13:10:16:95:7D
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:11
[root@purgatory WPC54Gv2_40826]# iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11b+/g+ ESSID:"CHRAV"
Nickname:"purgatory.bakouria.org"
Mode:Managed Frequency:2.412 GHz Access Point:
00:00:00:00:00:00
Bit Rate:54 Mb/s Tx-Power=15 dBm Sensitivity=1/3
Retry min limit:7 RTS thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@purgatory WPC54Gv2_40826]# iwlist wlan0 scan
wlan0 No scan results
Any help appreciated .