Network card failing (FC3)

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



2.6.11-1.35_FC3smp

After a long installation, we set up a server on wich we installed a sw; one of the netword card starts getting disabled by it self.

We think that it may be because the dhcpd.conf may be causing that, but even turning service off it still doesn't work.

We tryed the card outside and it works, so isn't a hardware failure, and each time we set up the configuration for it, it only survive a few seconds and keeps failing.

eth1      Link encap:Ethernet  HWaddr 00:0D:88:2D:DB:47
          UP BROADCAST NOTRAILERS MULTICAST  MTU:1500  Metric:1
          RX packets:21293 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1373 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1750818 (1.6 MiB)  TX bytes:196495 (191.8 KiB)
          Interrupt:169 Base address:0x2400

...no ip assigned, even after we did it....

Aug 11 01:16:27 dhcp-mpt dhcpd: receive_packet failed on eth0: Network is down
Aug 11 01:16:27 dhcp-mpt NetworkManager:     SWITCH: old device no longer good, but no better device was available
Aug 11 01:16:27 dhcp-mpt network: Interrupción de la interfaz eth0:  succeeded
Aug 11 01:16:27 dhcp-mpt network: Interrupción de la interfaz eth1:  succeeded
Aug 11 01:16:27 dhcp-mpt network: Interrupción de la interfaz de loopback: succeded
Aug 11 01:16:27 dhcp-mpt sysctl: net.ipv4.ip_forward = 0
Aug 11 01:16:27 dhcp-mpt sysctl: kernel.sysrq = 0
Aug 11 01:16:27 dhcp-mpt sysctl: net.ipv4.conf.default.accept_source_route = 0
Aug 11 01:16:27 dhcp-mpt sysctl: net.ipv4.conf.default.rp_filter = 1
Aug 11 01:16:27 dhcp-mpt sysctl: kernel.core_uses_pid = 1
Aug 11 01:16:27 dhcp-mpt network: Configurando parámetros de red:  succeeded
Aug 11 01:16:27 dhcp-mpt kernel: ip_tables: (C) 2000-2002 Netfilter core team
Aug 11 01:16:27 dhcp-mpt kernel: Disabled Privacy Extensions on device c036dcc0(lo)
Aug 11 01:16:28 dhcp-mpt network: Activación de la interfaz de loopback:  succeded
Aug 11 01:16:28 dhcp-mpt kernel: ip_tables: (C) 2000-2002 Netfilter core team
Aug 11 01:16:29 dhcp-mpt kernel: tg3: eth0: Link is up at 100 Mbps, full duplex.
Aug 11 01:16:29 dhcp-mpt kernel: tg3: eth0: Flow control is on for TX and on for RX.
Aug 11 01:16:29 dhcp-mpt NetworkManager:     SWITCH: best device changed
Aug 11 01:16:29 dhcp-mpt NetworkManager: Activation (eth0) started...
Aug 11 01:16:30 dhcp-mpt network: Activando interfaz eth0:  succeeded
Aug 11 01:16:30 dhcp-mpt kernel: ip_tables: (C) 2000-2002 Netfilter core team
Aug 11 01:16:30 dhcp-mpt kernel: eth1: link down
Aug 11 01:16:31 dhcp-mpt NetworkManager: Restarting mDNSResponder.
Aug 11 01:16:31 dhcp-mpt NetworkManager: Activation (eth0) successful, device activated.
Aug 11 01:16:32 dhcp-mpt network: Activando interfaz eth1:  succeeded

last part of /var/log/messages (sorry about the spanish), i did it, then inmediatly i checked ifconfig and ip was assigned, then i checked ifconfig again, and it was gone...

Any ideas?




Daniel Vogel
exed@xxxxxxxxxxx
Computer Engineering.
Concepcion-Chile
Siempre sale el sol despues de la tormenta.



>From: yufan <iamyufan@xxxxxxxxx>
>Reply-To: For users of Fedora Core releases <fedora-list@xxxxxxxxxx>
>To: For users of Fedora Core releases <fedora-list@xxxxxxxxxx>
>Subject: Is there a way to open a website which supports IE only in Fedora?
>Date: Thu, 11 Aug 2005 12:44:43 +0800
>
>Hello all,
>i wanna enter a chatting website which most probabily contains some ASP
>staff hence Firefox fails to do that and it says "this website requires IE
>4.0 or above".Is there a way to solve this problem?Thanks in advance.
>yufan
>--
>fedora-list mailing list
>fedora-list@xxxxxxxxxx
>To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list

[Index of Archives]     [Current Fedora Users]     [Fedora Desktop]     [Fedora SELinux]     [Yosemite News]     [Yosemite Photos]     [KDE Users]     [Fedora Tools]     [Fedora Docs]

  Powered by Linux