> Hi, Kevin. Thanks for the step-by-step, I'll try it tonight and post the > results tomorrow. About your question, I did not see an easy way to > configure this on the Linux version of VMware. The Windows version have > an option to select the interface to bind to vmnet0, but the Linux > version do not. However, maybe you can edit /etc/modprobe.conf and > switch the aliases of the two boards, making the wireless one to be > eth0. vmware-config.pl always bridges vmnet0 to eth0, so it might work. [aaron hirsch] By default it binds to eth0, but during setup you can define eth1...although that really is only for the bridging not for NAT...if the host is configured to use NAT it will go out whatever interface has LAN/WAN connectivity... ----------------------------------------- This e-mail message is intended only for the named recipient(s) above. It may contain confidential information. If you are not the intended recipient you are hereby notified that any dissemination, distribution or copying of this e-mail and any attachment(s) is strictly prohibited. If you have received this e-mail in error, please immediately notify the sender by replying to this e-mail and delete the message and any attachment(s) from your system.
