On Wed, 3 Aug 2005, Marcelo Magno T. Sales wrote:
Em Qua, 2005-08-03 às 11:03 -0600, kevin.kempter@xxxxxxxxxxxxxxxxx
escreveu:
[...]
It works fine. The only bit I wish I could make work is networking via my
wireless connection (eth1). If anyone knows how to do this I would be
grateful for any advice....
Hope this helps...
/Kevin
Hi, Kevin. Thanks for the step-by-step, I'll try it tonight and post the
results tomorrow. About your question, I did not see an easy way to
configure this on the Linux version of VMware. The Windows version have
an option to select the interface to bind to vmnet0, but the Linux
version do not. However, maybe you can edit /etc/modprobe.conf and
switch the aliases of the two boards, making the wireless one to be
eth0. vmware-config.pl always bridges vmnet0 to eth0, so it might work.
Thanks,
Marcelo
AFAIK, bridged networking over wireless is not supported on Linux hosts.
(It wasn't before, and I haven't seen anything to indicate that things
have changed.) NAT networking works fine over wireless.
--
Matthew Saltzman
Clemson University Math Sciences
mjs AT clemson DOT edu
http://www.math.clemson.edu/~mjs
