I did not run the interactive system-config-display tool. How do I run that? Which command do I invoke to run the interactive tool? When you ran the interactive tool, did it resolve the 'Permission denied' problem? Bisi --- Jim Cornette <fc-cornette@xxxxxxxxxxxxxx> wrote: > Bisi wrote: > > >After two attempts, I was finally able to get > anaconda > >to install FC4 > >on IBM > >xSeries 240 server in text mode. I edited file > >/usr/share/hwdata/Cards > >inserting the blank line as suggested in the trail > for > >bug# 157972. I then ran kudzu, supplying the > >root > >password when prompted. However, kudzu kept coming > >back with Permission > >denied > >even though the root password I supplied is > correct. > > > >I have SELinux enabled (active) during > installation. I > >do not know if > >this has > >anything to do with 'Permission denied' I'm > getting. > > > >Has anyone come accross same problems? > > > >Bisi > > > > > > > > > > I've seen this problem also trying to launch the > "new" non-interactive > kudzu. The root password that I supplied was also > correct. > Have you tried to run the interactive > system-config-display tool to > configure your card? > > Jim > > -- > "Never ascribe to malice that which is caused by > greed and ignorance." > -- Cal Keegan > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: > http://www.redhat.com/mailman/listinfo/fedora-list > ____________________________________________________ Start your day with Yahoo! - make it your home page http://www.yahoo.com/r/hs
