On Thu, 2005-07-21 at 01:56 -0500, Robert Citek wrote: > Is there a way to specify at the boot prompt what module the kernel > should use for eth0 in order to do a network install of FC3? If not, > how can I rmmod the incorrect network module and load in the correct > network module during the early stages of the installation? > > I'm trying to install FC3 over the net, but FC3 is unable to get an > IP address. After cycling through the virtual consoles, I noticed > the message that FC3 loaded the tulip module for the NIC. From other > installs, I know that the tulip module won't work. Instead, FC3 > should be loading the de2104x. I've been googling for possible > solutions, but haven't found an answer, yet. I think if you boot with the "expert" option you may be able to select the driver manually from a list. Paul. -- Paul Howarth <paul@xxxxxxxxxxxx>
