Igor Guarisma wrote:
Did you run sensors-detect??
I just did, and created an /etc/modules.conf with just the lines
below in it.
Here's the last part of the output:
===============================================
To make the sensors modules behave correctly, add these lines to
/etc/modules.conf:
#----cut here----
# I2C module options
alias char-major-89 i2c-dev
#----cut here----
To load everything that is needed, add this to some /etc/rc* file:
#----cut here----
# I2C adapter drivers
modprobe i2c-i801
modprobe i2c-isa
# I2C chip drivers
modprobe eeprom
modprobe w83627hf
# sleep 2 # optional
/usr/bin/sensors -s # recommended
#----cut here----
WARNING! If you have some things built into your kernel, the list above
will contain too many modules. Skip the appropriate ones! You really should
try these commands right now to make sure everything is working properly.
Monitoring programs won't work until it's done.
====================================================
How can I tell which are built in? And which file should I put those
commands into?
As root, I ran the programs listed above, and now sensors outputs
===============================================
$ sensors
w83627thf-isa-0290
Adapter: ISA adapter
VCore: +1.48 V (min = +1.93 V, max = +1.93 V)
+12V: +12.59 V (min = +10.82 V, max = +13.19 V)
+3.3V: +3.04 V (min = +3.14 V, max = +3.47 V)
+5V: +4.93 V (min = +4.75 V, max = +5.25 V)
-12V: -14.91 V (min = -10.80 V, max = -13.18 V)
V5SB: +4.97 V (min = +4.76 V, max = +5.24 V)
VBat: +2.30 V (min = +2.40 V, max = +3.60 V)
fan1: 3054 RPM (min = 0 RPM, div = 2)
CPU Fan: 0 RPM (min = 0 RPM, div = 2)
fan3: 0 RPM (min = 0 RPM, div = 8)
M/B Temp: +59°C (high = +63°C, hyst = +55°C) sensor =
PII/Celeron diode
CPU Temp: +33.5°C (high = +120°C, hyst = +115°C) sensor = thermistor
temp3: +21.0°C (high = +120°C, hyst = +115°C) sensor = thermistor
ERROR: Can't get VID data!
alarms:
beep_enable:
Sound alarm disabled
eeprom-i2c-0-50
Adapter: SMBus I801 adapter at 0500
Memory type: DDR SDRAM DIMM
Memory size (MB): 256
=====================================================
What is the error related to VID data?
Or restarted lm_sensors??
I haven't done that, but it seems that I'm getting some info now.
Thanks.
Mike
--
p="p=%c%s%c;main(){printf(p,34,p,34);}";main(){printf(p,34,p,34);}
This message made from 100% recycled bits.
I can explain it for you, but I can't understand it for you.
I speak only for myself, and I am unanimous in that!
