Gordon Charrick wrote:
Philip Prindeville wrote:
Gordon Charrick wrote:
I've got a Matrox G400 (it has two VGA ports built-in) and just
hooked a second monitor to the other VGA port. When I run
system-config-display it gives me the option to enable the 2nd
monitor, but when I restart X the other monitor just sits there
stupidly like it's not getting a signal. Do I need any other
software to do this or is Fedora set up to run it out of the box?
Can you attach your /etc/X11/xorg.conf file?
-Philip
Sure, here it is.
# Xorg configuration created by system-config-display
Section "ServerLayout"
Identifier "Multihead layout"
Screen 0 "Screen0" LeftOf "Screen1"
Screen 1 "Screen1" 0 0
InputDevice "Mouse0" "CorePointer"
InputDevice "Keyboard0" "CoreKeyboard"
Option "Xinerama" "off"
Option "Clone" "on"
EndSection
Section "Files"
RgbPath "/usr/X11R6/lib/X11/rgb"
FontPath "unix/:7100"
EndSection
Section "Module"
Load "dbe"
Load "extmod"
Load "fbdevhw"
Load "glx"
Load "record"
Load "freetype"
Load "type1"
Load "dri"
EndSection
Section "InputDevice"
Identifier "Keyboard0"
Driver "kbd"
Option "XkbModel" "pc105"
Option "XkbLayout" "us"
EndSection
Section "InputDevice"
Identifier "Mouse0"
Driver "mouse"
Option "Protocol" "IMPS/2"
Option "Device" "/dev/input/mice"
Option "ZAxisMapping" "4 5"
Option "Emulate3Buttons" "yes"
EndSection
Section "Monitor"
Identifier "Monitor0"
VendorName "Monitor Vendor"
ModelName "LL-172C-B"
DisplaySize 340 270
HorizSync 24.0 - 82.0
VertRefresh 55.0 - 77.0
Option "dpms"
EndSection
Section "Monitor"
Identifier "Monitor1"
VendorName "Monitor Vendor"
ModelName "LCD Panel 1280x1024"
HorizSync 31.5 - 67.0
VertRefresh 50.0 - 75.0
Option "dpms"
EndSection
Section "Device"
Identifier "Videocard0"
Driver "mga"
VendorName "Videocard vendor"
BoardName "Matrox Millennium G400"
EndSection
Section "Device"
Identifier "Videocard1"
Driver "mga"
VendorName "Videocard Vendor"
BoardName "Matrox Millennium G400"
BusID "PCI:1:0:0"
Screen 1
EndSection
Section "Screen"
Identifier "Screen0"
Device "Videocard0"
Monitor "Monitor0"
DefaultDepth 16
SubSection "Display"
Viewport 0 0
Depth 16
Modes "1280x1024" "1280x960" "1152x864" "1024x768"
"800x600" "640x480"
EndSubSection
EndSection
Section "Screen"
Identifier "Screen1"
Device "Videocard1"
Monitor "Monitor1"
DefaultDepth 16
SubSection "Display"
Viewport 0 0
Depth 16
Modes "1280x1024"
EndSubSection
EndSection
Section "DRI"
Group 0
Mode 0666
EndSection
What does "xdpyinfo" say? And what does your /var/log/Xorg.0.log file
look like?
-Philip
