Alexander Dalloz wrote:
> Am So, den 10.07.2005 schrieb Mike Noble um 21:50:
>
>
>>I can attach a usb hard drive and it is mounted and seen just fine
>>with FC4. When I put in my Kingston 512Mb memory stick, it does not
>>get loaded. Is there something special I have to do?
>>
>>Mike
>
>
> You should observe the syslog when plugging in the USB stick: tail -f
> /var/log/messages.
>
> Alexander
>
>
>
According to what the messages says it should be loaded:
Jul 10 13:11:42 mordor kernel: usb 1-3: new high speed USB device using
ehci_hcd and address 5
Jul 10 13:11:42 mordor kernel: scsi2 : SCSI emulation for USB Mass
Storage devices
Jul 10 13:11:47 mordor kernel: Vendor: Kingston Model: DataTraveler
2.0 Rev: 1.00
Jul 10 13:11:47 mordor kernel: Type: Direct-Access
ANSI SCSI revision: 00
Jul 10 13:11:48 mordor kernel: SCSI device sda: 974848 512-byte hdwr
sectors (499 MB)
Jul 10 13:11:48 mordor kernel: sda: Write Protect is off
Jul 10 13:11:48 mordor kernel: sda: assuming drive cache: write through
Jul 10 13:11:48 mordor kernel: SCSI device sda: 974848 512-byte hdwr
sectors (499 MB)
Jul 10 13:11:48 mordor kernel: sda: Write Protect is off
Jul 10 13:11:48 mordor kernel: sda: assuming drive cache: write through
Jul 10 13:11:48 mordor kernel: sda: sda1
Jul 10 13:11:48 mordor kernel: Attached scsi removable disk sda at
scsi2, channel 0, id 0, lun 0
Jul 10 13:11:48 mordor scsi.agent[3132]: disk at
/devices/pci0000:00/0000:00:1d.7/usb1/1-3/1-3:1.0/host2/target2:0:0/2:0:0:0
Jul 10 13:11:48 mordor fstab-sync[3156]: added mount point
/media/KINGSTON for /dev/sda1
But in doing an df -a, I get:
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/hda5 10418424 3265616 6615036 34% /
/dev/proc 0 0 0 - /proc
/dev/sys 0 0 0 - /sys
/dev/devpts 0 0 0 - /dev/pts
/dev/shm 257536 0 257536 0% /dev/shm
/dev/hda7 28174428 7389184 19330964 28% /home
none 0 0 0 -
/proc/sys/fs/binfmt_misc
sunrpc 0 0 0 -
/var/lib/nfs/rpc_pipefs
Mike
--
Mike Noble
mgnoble@xxxxxxxxx
Key ID: 0xFFDFC13B
Keyserver: http://pgpkeys.mit.edu
