I just installed FC3 on an IBM Thinkpad 600X, I have been able to get the
Cisco Airnet 350 Card to work, however it periodically at random times stop
working. By going to the "Network Device Control" and choosing "Deactivate"
followed by and "Activate" on the "eth0" interface, the wireless comes
back alive.
Sometimes I can go an hour or two with no problems other times I can only
go a few minutes.
Some information..
OS FC3 all patches from up2date were loaded.
Network Device control shows two interfaces...
wifi0 and eth0
output from iwconfig:
lo no wireless extensions.
sit0 no wireless extensions.
eth0 IEEE 802.11-DS ESSID:"my-ap" Nickname:"laptop"
Mode:Managed Frequency:2.417 GHz Access Point: 00:13:7F:33:68:E0
Bit Rate:11 Mb/s Tx-Power=20 dBm Sensitivity=0/65535
Retry limit:16 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=153/160 Signal level=-61 dBm Noise level=-90 dBm
Rx invalid nwid:13221 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:9 Invalid misc:64826 Missed beacon:0
wifi0 IEEE 802.11-DS ESSID:"GK-Customer" Nickname:"laptop"
Mode:Managed Frequency:2.417 GHz Access Point: 00:13:7F:33:68:E0
Bit Rate:11 Mb/s Tx-Power=20 dBm Sensitivity=0/65535
Retry limit:16 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=153/160 Signal level=-61 dBm Noise level=-90 dBm
Rx invalid nwid:13221 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:9 Invalid misc:64826 Missed beacon:0
Suggestions???
TIA
Jeff
