Hi Folks, Can anyone shed any light on the following? This is what happens after I put an SD card in my USB SD card reader: $ dmesg (trimmed) usb 2-2.4: new full speed USB device using ohci_hcd and address 5 scsi2 : SCSI emulation for USB Mass Storage devices usb-storage: device found at 5 usb-storage: waiting for device to settle before scanning Vendor: SanDisk Model: SDDR33USB/SDMMC Rev: 1.09 Type: Direct-Access ANSI SCSI revision: 02 Attached scsi removable disk sde at scsi2, channel 0, id 0, lun 0 usb-storage: device scan complete SCSI device sdc: 250881 512-byte hdwr sectors (128 MB) sdc: Write Protect is off sdc: Mode Sense: 00 00 00 00 sdc: assuming drive cache: write through sdc: sdc1 $ ls /media cdrecorder cdrecorder1 $ sudo mkdir /media/card $ mount /dev/sdc1 /media/card mount: only root can do that $ sudo mount /dev/sdc1 /media/card mount: special device /dev/sdc1 does not exist $ $ ls -la /dev/sdc* brw-rw---- 1 root disk 8, 32 Apr 13 21:10 /dev/sdc ...if I recall correctly, this used to work. I can't explain what's changed. Any ideas would be appreciated. -- Ben Steeves _ bcs@xxxxxxxxxx The ASCII ribbon campaign ( ) ben.steeves@xxxxxxxxx against HTML e-mail X GPG ID: 0xB3EBF1D9 http://www.metacon.ca/bcs / \ Yahoo Messenger: ben_steeves
