On Tuesday, March 22, 2005 9:00 AM Les Mikesell wrote: > >Note that if you start down this route you must forever >manually set *every* piece of equipment plugged into your >network to full duplex. The problem is that setting one end >turns off autonegotiation so if the other end is left at auto >it must assume half duplex. Now that most equipment gets it >right I'd recommend loading the latest IOS on your cisco >equipment and throw away anything that still doesn't do the >negotiation correctly when both ends are set to auto. My experiences have shown this not to be the case. The clients are properly setting themselves to 100/Full, even though the switches are forced to 100/full, yet the clients are left on autonegotiate. -- Shawn