On Mon, 2005-03-14 at 23:50 +0100, Eric Tanguy wrote: > i tried a lot of thing to solve my problem and maybe it could be a > module problem : > modprobing bttv seems to give good results and all is autodetected (the > tuner seems to be the right one) : > bttv: driver version 0.9.15 loaded > bttv: using 8 buffers with 2080k (520 pages) each for capture > bttv: Bt8xx card found (0). > ACPI: PCI interrupt 0000:01:07.0[A] -> GSI 11 (level, low) -> IRQ 11 > bttv0: Bt878 (rev 17) at 0000:01:07.0, irq: 11, latency: 64, mmio: > 0xeb800000 > bttv0: detected: Pinnacle PCTV [card=39], PCI subsystem ID is 11bd:0012 > bttv0: using: Pinnacle PCTV Studio/Rave [card=39,autodetected] > bttv0: gpio: en=00000000, out=00000000 in=00fff3ff [init] > bttv0: i2c: checking for MSP34xx @ 0x80... not found > bttv0: pinnacle/mt: id=4 info="PAL+SECAM / mono" radio=no > bttv0: using tuner=33 > bttv0: i2c: checking for MSP34xx @ 0x80... not found > bttv0: i2c: checking for TDA9875 @ 0xb0... not found > bttv0: i2c: checking for TDA7432 @ 0x8a... not found > tda9885/6/7: chip found @ 0x96 > tuner: chip found at addr 0xc0 i2c-bus bt878 #0 [sw] > tuner: type set to 33 (MT20xx universal) by bt878 #0 [sw] > tuner: microtune: companycode=3cbf part=42 rev=2f > tuner: microtune MT2050 found, OK > bttv0: registered device video0 > bttv0: registered device vbi0 > bttv0: PLL: 28636363 => 35468950 . ok > > The problem is i receive no signal in tvtime whereas this card works > fine under windows. It seems the system cannot set the right tuner > frequency : > > mt2050_set_if_freq failed with -121 > > Someone could help me ? Eric, Take a look at this thread. http://groups-beta.google.com/group/linux.kernel/browse_thread/thread/58bd50364a5b47d8/81b8dfdd7bed9d95?q=linux+Pinnacle+PCTV+rave+tuner#81b8dfdd7bed9d95 It looks like there is a patch. Also, one of the posters said it worked in 2.6.9. Do you have a 2.6.9 version of the kernel still around? BTW: I don't see why your question was off-topic on the "other list". Bob...
