I see the following in /var/log/messages concerning a USB hard drive.
Feb 15 17:00:16 s2 kernel: usb 1-2: new full speed USB device using ohci_hcd and address 2
Feb 15 17:00:16 s2 kernel: Initializing USB Mass Storage driver...
Feb 15 17:00:16 s2 kernel: scsi3 : SCSI emulation for USB Mass Storage devices
Feb 15 17:00:16 s2 kernel: usbcore: registered new driver usb-storage
Feb 15 17:00:16 s2 kernel: USB Mass Storage support registered.
...
Feb 15 17:00:16 s2 kernel: Vendor: ST320420 Model: A Rev: 3.21
Feb 15 17:00:16 s2 kernel: Type: Direct-Access ANSI SCSI revision: 00
Feb 15 17:00:16 s2 kernel: SCSI device sdd: 39851761 512-byte hdwr sectors (20404 MB)
Feb 15 17:00:16 s2 kernel: sdd: assuming drive cache: write through
Feb 15 17:00:16 s2 kernel: SCSI device sdd: 39851761 512-byte hdwr sectors (20404 MB)
Feb 15 17:00:16 s2 kernel: sdd: assuming drive cache: write through
Feb 15 17:00:16 s2 kernel: sdd: sdd1
Feb 15 17:00:16 s2 kernel: Attached scsi disk sdd at scsi3, channel 0, id 0, lun 0
Yet, there is no /dev/sdd1.
root@s2 ~# mount /dev/sdd1 /media/usbdisk/ mount: special device /dev/sdd1 does not exist
How do I get access to the device?
-- Bill Gradwohl bill@xxxxxxx http://www.ycc.com spamSTOMPER Protected email
