On Wednesday 09 February 2005 19:28, david walcroft wrote: >j wrote: >> LignumCAD is a furniture CAD program from freshmeat and >> sourceforge. I get an error message about the default application >> font being either Type 1 or TrueType. I have both installed. The >> message says to run qtconfig 3.0, but I have 3.3.3. The program is >> from a rpm dated 2003 so it would probably work if I recompiled >> the code. The rpm wants /usr/X11R6/lib/X11/XftConfig which doesn't >> exist on my machine. I just wondered if anyone has had any luck >> with the program. It looks like the author had originally put lots >> of work into it, then ... >> thanks, >> jeff hilson > >I tried it late last year,but it could never config well enough to > run the program,it is'nt maintained any more AFAIK and seemed to be > built for RH9/FC1. > > david I just ran it on an FC2 system, with a 2.6.11-rc3-RT-V0.7.38-06 kernel. I didn't see any problems. Like you, I was hopeing it would get more developement, like for mortise and tenon joints and such. But sadly, no further progress seems to have been made since 0.2. -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) 99.33% setiathome rank, not too shabby for a WV hillbilly Yahoo.com attorneys please note, additions to this message by Gene Heskett are: Copyright 2005 by Maurice Eugene Heskett, all rights reserved.
