Hi at all! someone of you know if is possible to burn from scsi cdrecorder on fedora 3? because xcdroast and k3b see only /dev/sg0 and /dev/sg1, but from this kind of devices is imposible to burn..normally the corrects devices should be sr or scd any idea? many many thanks!! this is my configuration: fedora 3, kernel vanilla 2.6.9 with scsi support, udev, and this dmesg output: dc395x: Used settings: AdapterID=07, Speed=0(20.0MHz), dev_mode=0x57 > dc395x: AdaptMode=0x0f, Tags=4(16), DelayReset=1s > dc395x: Connectors: int50 Termination: Auto Low High > dc395x: Performing initial SCSI bus reset > scsi0 : Tekram DC395(U/UW/F), DC315(U) - ASIC TRM-S1040 v2.05, 2004/03/08 > dc395x: Target 03: Sync: 48ns Offset 15 (20.8 MB/s) > Vendor: YAMAHA Model: CRW8424S Rev: 1.0g > Type: CD-ROM ANSI SCSI revision: 02 > dc395x: Target 05: Sync: 48ns Offset 15 (20.8 MB/s) > Vendor: PLEXTOR Model: CD-ROM PX-40TS Rev: 1.10 > Type: CD-ROM ANSI SCSI revision: 02 > sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray > Uniform CD-ROM driver Revision: 3.20 > Attached scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0 > sr1: scsi-1 drive > Attached scsi CD-ROM sr1 at scsi0, channel 0, id 5, lun 0 > Attached scsi generic sg0 at scsi0, channel 0, id 3, lun 0, type 5 > Attached scsi generic sg1 at scsi0, channel 0, id 5, lun 0, type 5
