hi, i'm davide from italy i've installed Fedora 3 and a new kernel vanilla 2.6.9 with complete scsi support on my pc there are one cdreader ide, one cdreader scsi, and one cdwriter scsi now, dmesg show me correcly all devices (dc395x: Tekram DC395(U/UW/F), DC315(U) - ASIC TRM-S1040 v2.05, 2004/03/08 ACPI: PCI interrupt 0000:00:11.0[A] -> GSI 10 (level, low) -> IRQ 10 dc395x: Used settings: AdapterID=07, Speed=0(20.0MHz), dev_mode=0x57 dc395x: AdaptMode=0x0f, Tags=4(16), DelayReset=1s dc395x: Connectors: int50 Termination: Auto Low High dc395x: Performing initial SCSI bus reset scsi0 : Tekram DC395(U/UW/F), DC315(U) - ASIC TRM-S1040 v2.05, 2004/03/08 dc395x: Target 03: Sync: 48ns Offset 15 (20.8 MB/s) Vendor: YAMAHA Model: CRW8424S Rev: 1.0g Type: CD-ROM ANSI SCSI revision: 02 dc395x: Target 05: Sync: 48ns Offset 15 (20.8 MB/s) Vendor: PLEXTOR Model: CD-ROM PX-40TS Rev: 1.10 Type: CD-ROM ANSI SCSI revision: 02 PIIX4: IDE controller at PCI slot 0000:00:07.1 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later PIIX4: port 0x01f0 already claimed by ide0 PIIX4: port 0x0170 already claimed by ide1 PIIX4: neither IDE port enabled (BIOS) EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds NET: Registered protocol family 1 sr0: scsi3-mmc drive: 16x/16x writer cd/rw xa/form2 cdda tray Uniform CD-ROM driver Revision: 3.20 Attached scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0 sr1: scsi-1 drive Attached scsi CD-ROM sr1 at scsi0, channel 0, id 5, lun 0 hdd: ATAPI 52X CD-ROM drive, 128kB Cache) BUT I CANNOT BURN FROM /dev/sr0 or /dev/scd0.. BUT I CAN READ FROM THEM (from /dev/scd0 and from /dev/scd1) i think same udev mistakes..or one Tecram module(dc395x) bug? anyone of you have hany suggestion? many many thanks!! ciao!!
