Re: trouble installing printer driver

[Riku Seppälä <riku.seppala@xxxxxxxx>]

Paul Howarth wrote:

> Riku Seppälä wrote:
>
> > I'm running FC3. I have lexmark p3150 printer, cups doesen't have 
> > driver for it. I found driver from here: 
> > http://users.cybercity.dk/~dko12479/
> > Installed the z700llpddk-2.0-1.i386.rpm 
> > <http://users.cybercity.dk/%7Edko12479/z700llpddk-2.0-1.i386.rpm> 
> > with no problem, but can't install the 
> > lexmark-z700-cups-driver-1.1.1-1.i586.rpm 
> > <http://users.cybercity.dk/%7Edko12479/lexmark-z700-cups-driver-1.1.1-1.i586.rpm>: 
> >
> > error: Failed dependencies:
> >        libcrypto.so.0.9.7 is needed by 
> > lexmark-z700-cups-driver-1.1.1-1.i586
> >        libssl.so.0.9.7 is needed by 
> > lexmark-z700-cups-driver-1.1.1-1.i586
> >
> > I made the sympolic links just like it was suggested on the page, but 
> > it changed nothing.  Any advice?
>
>
> Remove the links you made, which are a horrible hack and may cause 
> confusion later. The problem you are having is that the package was 
> built against openssl-0.9.7 whereas FC3 includes openssl-0.9.7a, which 
> has a slightly different (and not fully compatible) interface.
>
> If you follow the "Source installation" instructions, you should end 
> up with a version that is compatible with FC3.
>
> Paul.
OK, I removed the links. Tried the source installation, there is no 
configure just makefile. I did make, make install, everything looked ok. 
But printer configuration don't show any new lexmark models. Maybe I'm 
missing something.. have to check everything again.

Riku Seppälä