Hi,
I'm trying to get my netgear ma401 802.11b PCMCIA wifi card working.
it worked under slackware. I'm confused if this is a orinoco chipset or prism
here is what's confusing me:
dmesg:
[most of it snipped just pasting the part relevant to this card]
cs: memory probe 0xa0000000-0xa0ffffff: clean.
orinoco 0.13e (David Gibson <hermes@xxxxxxxxxxxxxxxxxxxxx>, Pavel Roskin <proski@xxxxxxx>, et al)
orinoco_cs 0.13e (David Gibson <hermes@xxxxxxxxxxxxxxxxxxxxx>, Pavel Roskin <proski@xxxxxxx>, et al)
divert: allocating divert_blk for eth1
eth1: Station identity 001f:0006:0001:0003
eth1: Looks like an Intersil firmware version 1.3.6
eth1: Ad-hoc demo mode supported
eth1: IEEE standard IBSS ad-hoc mode supported
eth1: WEP supported, 104-bit key
eth1: MAC address 00:09:5B:23:3B:D6
eth1: Station name "Prism I"
eth1: ready
eth1: index 0x01: Vcc 5.0, irq 3, io 0x0100-0x013f
at the top of the message it shows orinoco 0.13... and at the bottom it calls eth1: Station name "Prism I"
Anyone know what this means?
When I put the card in and try to use KWIFI manager it shows a picture of the pcmcia card with a ? question mark going thru it as if it is unrecognized. of course i do not connect. Also it just occurred to me that I juse gnome and this is a KDE utility. should i be using something else when in Gnome for wifi management. in any case ifconfig shows i'm not connected.
i'm using FC3 2.6.10-1.741_FC3 on a compaq r3000 presario p4
mike hoy
