Re: eth0 problems

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, 2004-12-23 at 14:07 +0000, Paul Howarth wrote:

> What's the output of:
> 
> # grep eth0 /etc/modprobe.conf
> # cat /etc/sysconfig/network-scripts/ifcfg-eth0

On booting I get the following:

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Bringing up interface eth0:
Determining IP information for eth0...PING 192.168.178.1 (192.168.178.1)
56(84) bytes of data.

--- 192.168.178.1 ping statistics ---
4 packets transmitted, 0 received, +3 errors, 100% packet loss, time
2999ms
, pipe 4
PING 192.168.178.1 (192.168.178.1) 56(84) bytes of data.

--- 192.168.178.1 ping statistics ---
4 packets transmitted, 0 received, +3 errors, 100% packet loss, time
2999ms
, pipe 4
failed.
[FAILED]
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

My network card is ...

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Broadcom Corporation NetXtreme BCM5788 Gigabit Ethernet
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

ifconfig command output is ...

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:3343 errors:0 dropped:0 overruns:0 frame:0
TX packets:3343 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4174142 (3.9 MiB) TX bytes:4174142 (3.9 MiB)
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

route command output ...

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
169.254.0.0 * 255.255.0.0 U 0 0 0
lo
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

ifcfg-eth0 file output ...

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
# Please read /usr/share/doc/initscripts-*/sysconfig.txt
# for the documentation of these parameters.
IPV6INIT=no
onBOOT=yes
USERCTL=no
PEERDNS=yes
TYPE=Ethernet
DEVICE=eth0
HWADDR=00:c0:9f:42:33:e6
BOOTPROTO=dhcp
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

I must boot my new kernel to get /etc/modprobe.conf.
-- 
Maciek R. <m.mail@xxxxx>


[Index of Archives]     [Current Fedora Users]     [Fedora Desktop]     [Fedora SELinux]     [Yosemite News]     [Yosemite Photos]     [KDE Users]     [Fedora Tools]     [Fedora Docs]

  Powered by Linux