Hello out there, I followed the description on this site - http://www.linuxelectrons.com/article.php/20040507104718960 - in order to install the driver for my WLAN card 'Broadcom 802.11g'. It think the installation was ok. But as soon as I try to activate the card, I am getting: ----------------------------------------------------------------------- Error for wireless request "Set Bit Rate" (8B20) : SET failed on device wlan0 ; Operation not supported. Error for wireless request "Set Encode" (8B2A) : SET failed on device wlan0 ; Invalid argument. Determining IP information for wlan0... failed; no link present. Check cable? ----------------------------------------------------------------------- What may be wrong? -- Maciek R. <m.mail@xxxxx>
