On Fri, 2004-12-17 at 23:54 +0100, M Daniel R M wrote: > El jue, 16-12-2004 a las 21:47 -0700, Thornton escribió: > > On Tue, 2004-12-14 at 11:19 -0700, Thornton wrote: > > > Xsane seems to work fine if I scan within GIMP. > > > > > > However if I try to scan from Kooka all it does is start to scan then > > > dies. You can here the scanner kick on then shut off and Kooka just does > > > nothing. > > > > > > I am using a Canon LIDE 50 scanner. Kooka works with this same scanner > > > on a different PC. > > > > I've tried reinstalling kooka and that didnt seem to do anything. Any > > other ideas? > > > > Thanks! > > > I'm sorry if this was suggested yet, I didn't pay attention to this > thread.. > Also I don't know kooka software nor that kind of scanner but... > did you check permissions for that in /proc/bus/usb/ ? -supposing to be > an usb scanner... > > Cheers > > M Daniel R M i'll go check permissions but if that was it i dont think xsane would be able to access the scanner. or would it? will check the permissions when i get home though
